Table of Contents
Advertisement
S
S
UPER
ERVER 5015B-MF User's Manual
6-5
Power Supply
The SuperServer 5015B-MF has a single 260 watt power supply. This power sup-
ply has the capability of operating at 100 - 240 input volts. Shutdown the system
and then unplug the AC power cord to completely remove power from the system
before removing the power supply.
Power Supply Failure
If the power supply unit fails, the system will shut down and you will need to replace
the power supply unit. Replacement units can be ordered directly from Supermicro
(PWS-0055 - see contact infomation in Chapter 1).
Replacing the Power Supply
1.
To access the inside of the chassis, follow the procedure as described on
page 6-3.
2.
Shut down the system and unplug the power cord.
3.
To remove the failed power unit, remove the two screws on the back of the
power supply, which secure it to the chassis. You can then lift the unit straight
out of the chassis.
4.
Replace the failed unit with another unit of the same wattage. It is highly
recommended to replace it with the exact same power supply. Carefully insert
the new unit into position in the chassis and secure it with the two screws at
the rear of the unit.
5.
Before reconnecting the power cord, make sure the power switch on the
power supply is in the off position. Then reconnect the power cord, replace
the chassis top cover and push the unit back into the rack.
6.
Finish by depressing the power button on the front of the system.
6-6
Advertisement
Table of Contents
