Commissioning
Measuring cycle
Carrying out
settings
18
3.4.3 Settings for the main sensor
A measuring cycle consists of the cleaning procedure, the adjustment time for
the measuring system and the determination of the measured value. The follow-
ing graphic demonstrates the relevant settings:
Measuring
cycle
Measuring interval
Fig. 3-6
Measuring cycle of the sensor
Using <S>, switch from the measured value display to the main menu of the
settings. Then navigate to the setting menu (setting table) of the sensor. The
procedure is described in detail in your IQ S
manual.
A change of the following settings will take some time (up to a few
minutes) until it can be seen in the measured value display:
Measuring mode
Measuring location
Number of C-sensors
Further changes can only be made when the last changes are visi-
ble in the measured value display.
CarboVis 70x IQ TS
Time
N
system operating
ENSOR
ET
ba75950e03
05/2017