Table of Contents
Advertisement
CarboVis 70x IQ TS
Result
Sensor
after
check (standard)
Completing the
sensor check or
Zero adjustment
ba75950e03
05/2017
If no valid zero adjustment is possible under the current conditions,
you can restore the readiness for measurement by measuring with
an older valid zero adjustment.
To do so, select the
Factory
(factory zero adjustment) or
adjustment).
Then check the measurement results with a
dard)
. Suitable standards (check equipment) for your sensor are
available as accessories (see chapter 6).
Result
Meaning
OK
Sensor check (standard)
Error
Sensor check (standard)
Possible cause: wrong or expired standard
After a successful sensor check or
follows:
17.
Confirm the calibration result with <OK>.
18.
Confirm the message,
The display returns to the measured value display. The measured value
flashes because the sensor is still in the maintenance condition.
19.
Pour away the ultrapure water or standard solution and remove the
sensor sleeve.
20.
Screw in the blind plug or compressed air connector and install the sen-
sor at the measuring site.
Sensor check (standard)
21.
After the
Thoroughly rinse the sensor and sensor sleeve with ultrapure water.
22.
CarboVis 70x IQ TS Switch off the maintenance condition (use
<> to select the sensor, press <OK> and make the setting in
Display/Options
the
23.
Switch to the measured value display with <M>. The measured value
stops flashing.
Store the sensor sleeve in a clean environment, e. g. in a plastic
bag, until the next sensor check or
Zero adjustment
User
successful.
not successful.
Zero adjustment
"After successful cal ..."
:
menu).
Zero adjustment
Measurement / Operation
setting in the sensor settings
(last valid user zero
Sensor check (stan
, return to measurement as
with <OK>.
.
-
37
Advertisement
Table of Contents
