Table of Contents
Advertisement
CarboVis 70x IQ TS
Menu item
Measuring mode
Measuring location
Measuring range
Cal - # raw value 1
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
Number of C-sensors
ba75950e03
05/2017
Default values are marked in bold.
Settings
COD spectr., total
COD spectr., dissolv
TOC spectr., correl.
BOD spectr., correl.
DOC spectr., correl.
SAC 254, total
SAC 254, dissolved
UVT 254, total
UVT 254, dissolved
Outlet
Inlet
Activation
-
Value pairs of the user calibration (see section 4.3.2).
Note: Leave those values unchanged during the initial commission-
ing.
1 ... 4
Explanations
The measured parameter is displayed
in the selected citation form.
When changing the
setting, always check the
location
setting.
If the previously set measurement loca-
tion is not available for the selected
measuring mode, the measurement
location is automatically changed.
Measurement location or application of
the sensor.
The possible measurement loca-
tions are displayed depending on the
currently set measuring mode.
The sample matrix on which the cal-
culation of the measured value is
based changes with the location of
the sensor.
The measurement location
can only be selected for
mode COD spectr., dissolv
When the measurement location is
changed, all virtual sensors are
deleted.
Display of the measuring range
(see chapter 8 T
ECHNICAL DATA
Apart from the main sensor, up to 4
more sensors can be displayed.
The settings for the additional sensors
are done in the menus for the respec-
tive sensors.
Commissioning
Measuring mode
Measuring
Activation
Measuring
.
).
19
Advertisement
Table of Contents
