Table of Contents
Advertisement
https://daikin-p.ru
※18 FA Calibration (Option)
Go to FA Calibration in Manual Check first, then set ventilation volume.
Manual Check
2/3
FA Calibration
200 mm
PREV
NEXT
Step 1.
Fully open
FA intake
air hole
Ventilation
cover
FA Discharge
air hole
Setting value of
ventilation volume
※19 Trip Start Time
Go to Trip Start reset by pressing
FA Calibration
Trip Start Time
Comp Running Hrs
PREV
※20 Comp. Running Hrs
1. Current Compressor Running Hrs is 1000 Hr as example below.
2. When compressor is replaced, it's recommended to reset 0 Hr by pressing
Trip Start Time
Comp Running Hrs
EFH Running Hrs
PREV
Follow the same procedure for EFH, EFL, CFH and CFL running hrs.
※21 EFH Running Hrs
※22 EFL Running Hrs
Manual Check
2/3
Step 1. Fully open Ventilation
cover
Step 2. Close ventilation
cover to zero point
Step 4 : Press ENTER
3 mm
ESC : Cancel
Step 2-1.
Step 2-2.
Fully close
Lift up the cover a little
and tighten 4 wing bolts
after making the zero-
point adjustment.
Zero point
Sensor Information
Ventilation Volume
PREV
key for 3 seconds.
Manual Check
2/3
3mm
3 seconds
7Day12Hr
1000Hr
NEXT
Manual Check
2/3
7Day12Hr
3 seconds
1000Hr
600Hr
NEXT
Manual Check
Complete
0mm
ESC : Return
●After completing calibration,
set ventilation volume.
①Fully open
4 wing bolts
①Fully open ventilation cover
②Close it gradually until set value of the
ventilation volume is displayed. Then
3/3
tighten 4 wing bolts.
Ventilation volume is confirmed in the display
50 m3/h
according to＊3 Sensor Information or battery
mode of ＊15 Data Information in paragraph 2.3.
Manual Check
FA Calibration
Trip Start Time
Comp Running Hrs
PREV
Manual Check
Trip Start Time
Comp Running Hrs
EFH Running Hrs
PREV
※23 CFH Running Hrs
※24 CFL Running Hrs
4-5
Manual Check
2/3
FA Calibration
PREV
FA opening 0 mm
after calibration
②Set ventilation
volume.
2/3
3mm
0Hr
1000Hr
NEXT
key for 3 seconds.
2/3
7Day12Hr
0Hr
600Hr
NEXT
2/3
0 mm
NEXT
Advertisement
Table of Contents
