Table of Contents
Advertisement
4.3. Connection-Possibilities of the Function Control
• Use as air pressure outlet during screw-assembly:
to control driver start and stop, as well as shut-off control of clutch;
-
as cycle counter of the complete process;
-
each in connection with a PE- Switch or similar.
• Use as air pressure inlet:
if 6,3 bar (90 PSI) air pressure is given to the function control port,
-
the driver starts rotating at about 15 % of its speed. This will
simplify the engagement of bit/socket to fastener (for example
when driving hex screws, nuts, etc.)
4.4. To adjust the sensor finder
See picture To adjust the sensor finder
Coarse Adjustment:
Sensor finder exceeds the bit tip by approx. 2 mm.
Fine Adjustment:
Test-drive the SENSOMAT screwdriver for final adjustment.
1.
In case the screw is not tightened all the way (SENSOMAT-clutch shuts-
off too early, despite preset torque), loosen the counter nut and slightly
tighten sensor finder (left-hand thread).
2.
In case the screw strips (SENSOMAT-clutch does not shut-off despite
preset torque), loosen counter nut and slightly unscrew sensor finder (left
hand thread).
15
Advertisement
Table of Contents
