Eaton Powerware Series Mechanical Installation Manual page 16

FIELD INSTALLED UPM INSTALLATION PLAN AND UNPACKING
3−6
EATON 9395 Field Installed UPM Mechanical Installation Manual
Do not tilt the FI−UPM cabinet more than 10° from vertical or the cabinet may tip over.
3. Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft)
on each side for removing the cabinet from the pallet.
NOTE The FI−UPM cabinet is shipped with a debris shield covering the ventilation grill on top of the unit.
Do not remove the debris shield until installation is complete.
4. Remove the protective covering from the cabinet.
5. Remove the packing material, and discard or recycle in a responsible manner.
6. Inspect the contents for any evidence of physical damage, and compare each
item with the Bill of Lading. If damage has occurred or shortages are evident,
contact an Eaton service representative immediately to determine the extent of
the damage and its impact on further installation.
NOTE While waiting for installation, protect the unpacked cabinet from moisture, dust, and other harmful
contaminants. Failure to store and protect the FI−UPM properly may void your warranty.
Figure 3-7. Eaton 9395 FI−UPM Cabinet as Shipped on Pallet
S
C A U T I O N
164201717 Rev 3 www.eaton.com/powerquality