Download
Share
Print this page
Eaton Powerware User Manual
  1. Manuals
  2. Brands
  3. Eaton Manuals
  4. Smoke Alarm
  5. Powerware Series
  6. User manual
Eaton Powerware User Manual

Eaton Powerware User Manual

Hide thumbs Also See for Powerware:

Advertisement

Quick Links

Download this manual
Powerware Smoke Detector
®
User's Guide

Advertisement

loading
Need help?

Need help?

Do you have a question about the Powerware and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Eaton Powerware

Summary of Contents for Eaton Powerware

  • Page 1 Powerware Smoke Detector ® User’s Guide...
  • Page 2 Powerware is a registered trademark of Eaton Electrical Inc. ECopyright 2007 Eaton Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced in any way without the express written approval of Eaton Corporation.

  • Page 3: Smoke Detector

    Near electrical lights (electrical “noise” from the lights may cause a nuisance alarm). Place the smoke detector at least 1.5m (5 ft) from such lights. The smoke detector is a device that works with the Eaton Powerware Environmental Rack Monitor (ERM) and connects to the TH-Module.

  • Page 4: Installation

    7. Attach the smoke detector cover to the base by turning it clockwise until it latches. The smoke detector is now operating. NOTE The smoke detector cover will not attach to the base unless a battery is installed. EATON Powerware ® Smoke Detector User’s Guide...
  • Page 5 TH-Module alarm 1 or alarm 2 connectors, then tighten the TH-Module screws (see Figure 2). Orange Wire Blue Wire Figure 2. TH-Module with Smoke Detector Wires 11. If you are installing additional smoke detectors, repeat Steps 1 through 10. EATON Powerware ® Smoke Detector User’s Guide 164201680 Rev 1...
  • Page 6 13. Connect the other end of the RJ-45 network cable to the ERM (see Figure 4). RESET NETWORK TH-Module-1 TH-Module-2 12 VDC To LAN port To Power Outlet TH-Module Figure 4. ERM and TH-Module EATON Powerware ® Smoke Detector User’s Guide 164201680 Rev 1...
  • Page 7 16. Set the status of alarm 1 and/or alarm 2 to “Normal Close” and select “Smoke Alarm.” 17. Select to confirm the smoke detector setup. Set Value Figure 5. Smoke Detector Settings EATON Powerware ® Smoke Detector User’s Guide 164201680 Rev 1...
  • Page 8 If the alarm does not sound, replace the battery. Erratic noise or low sound from the smoke detector may indicate a defective detector. Return the smoke detector for service. EATON Powerware ® Smoke Detector User’s Guide 164201680 Rev 1...

  • Page 9: False Alarms

    NOTE For more detailed information that is not included in this manual, first register your product at warranty.powerware.com, then visit our Web site: www.powerware.com/rackmonitor. You can also download firmware upgrades, the latest manuals, and other documentation. EATON Powerware ®...
  • Page 10 SMOKE DETECTOR EATON Powerware ® Smoke Detector User’s Guide 164201680 Rev 1...
  • Page 12 *1642016801* 164201680 1...