Test Strip - Fora MD Control Operator's Manual

Test Strip

NOTE:
 The FORA MD Control blood glucose monitoring system should only be
used with FORA MD Control blood glucose Test Strips. Using other test
strips with this meter may produce inaccurate results.
5
1. Absorbent Hole
Apply a drop of blood here. The blood will be
automatically absorbed.
2.Confirmation Window
This is where you confirm if enough blood has been
applied to the absorbent hole of the strip.
3.Test Strip Handle
Hold this part to insert the test strip into the slot.
4.Contact Bars
Insert this end of the test strip into the meter.
Push it in firmly until it will go no further.
ATTENTION:
The front side of test strip should face up when
inserting test strip.
Test results might be wrong if the contact bar is not
fully inserted into the test slot.