Test Strip - Fora TD-3261G Owner's Manual

Test Strip

Front
The TD-3261G monitor should only be used with TD-3261G Test Strips.
Using other test strips with this meter can produce inaccurate results.
Absorbent Hole
1
Apply a drop of blood here.
The blood will be automatically absorbed.
Confirmation Window
2
This is where you confirm if enough blood
has been applied to the absorbent hole in
the strip.
Test Strip Handle
3
Hold this part to insert the test strip into
the slot.
Contact Bars
4
Insert this end of the test strip into the
meter. Push it in firmly until it will go no
further.
ATTENTION:
The front side of test strip should face up
when inserting test strip.
Test results might be wrong if the contact bar
is not fully inserted into the test slot.
NOTE
13