Advertisement

Blood Glucose Monitoring System
1

Insert Test Strip

1. Insert the contact bars end of the test strip into the meter. Push it in firmly until it will go no further.
2
1.Use a safety lancet
to obtain a drop of blood.
You will only need 0.7μL
for a test.
3

Obtain Result and Discard Strip

1. After 7 seconds, the meter
will beep, your blood glucose
result will be displayed
and stored in meter memory.
GD
20
Front
Back
The front side of the
test strip should face
up when inserting
the test strip.
2. Hold the drop close to the edge of the
test strip and allow the sample to wick
automatically into the absorbent hole.
2. Eject the used test strip by
pushing up the test strip
eject button.
QUICK REFERENCE GUIDE
3. Do not smear blood onto the strip or try
to place blood on top of the strip. When
the absorbent hole is filled, the meter will
start the countdown from 7 seconds.
3. Clean and/or disinfect the meter following either the
cleaning and disinfecting procedures outlined in the
Operations and Procedures Manual or per your facilities
cleaning protocol.
Customer Service: 888.425.1149
9247 Research Drive Irvine, CA 92618
www.linksmed.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GD20 and is the answer not in the manual?

Questions and answers

Summary of Contents for Fora GD20

  • Page 1 QUICK REFERENCE GUIDE Blood Glucose Monitoring System Insert Test Strip 1. Insert the contact bars end of the test strip into the meter. Push it in firmly until it will go no further. Front Back The front side of the test strip should face up when inserting the test strip.
  • Page 2 CONTROL SOLUTION TESTING TROUBLESHOOTING THE METER Result Readings W h e n t o P e r f o r m a C o n t r o l S o l u t i o n T e s t : MESSAGE WHAT IT MEANS •...

Table of Contents