Testing Your Blood Glucose; Inserting A Test Strip; Preparing The Lancing Device - Fora D40 DUO ultima Owner's Manual

Testing Your Blood Glucose

Test Strip Appearance
Apply a drop of blood here.
Hold this part to insert
the test strip into the slot.

Inserting a Test Strip

Insert the test strip as shown in the illustration.
Important!
The front side of test strip should face up when inserting test strip. Test
results might be wrong if the contact bar is not fully inserted into the
test slot.

Preparing the Lancing Device

1. Remove the cap.
2. Insert a new lancet firmly into the white lancet holder cup.
3. Remove the protective disk on the lancet.
Hold the lancet firmly in place and twist off the protective disk.
Absorbent Hole
Test Strip Handle
Confirmation Window
An area where you confirm
if enough blood has been
applied to the absorbent hole
in the strip.
Contact Bars
Insert this end of the test strip
into the meter. Push it in firmly
until it will go no further.
EN-9