Troubleshooting - HP Metal Jet S100 User Manual

of 10, 100, or 1000 Mbps, and to communicate using full- or half-duplex mode. However, you can manually
configure the link using the product's front panel, or through other configuration tools once network
communication is established.

Troubleshooting

If you have trouble with network communication, try these suggestions.
Link issues
The product has status lights (LEDs) beside the network connector that indicate the link status and
network activity.
● When the green light is on, the product has successfully linked to the network.
● When the yellow light is blinking, there is transmission activity over the network.
If the product fails to connect to the network, both LEDs will be off. In this situation, try the following
steps:
1. Check the cable connections at both ends.
2. Consider replacing the cables with ones that are known to work.
3. Consider switching to another network connector in the network switch, hub, or device to which the
product is connected.
4. Manually configure the link setting to match the port configuration of the network hub or switch.
5. In case of doubt or misconfiguration of link settings, reset the network parameters to their factory
settings.
Restore factory settings
In the case of accidental misconfiguration, you can reset the network settings to the factory defaults by
tapping Restore factory settings in the Network Settings configuration menu.
Troubleshooting 35