Maintenance; Preventive Maintenance - HP Metal Jet S100 User Manual

4

Maintenance

Hardware maintenance is sometimes needed to keep your product operating safely and efficiently.
WARNING!
installation, the designated personnel receive training for safe operation and maintenance of the
product. No-one should use the product without this training.

Preventive maintenance

Performing maintenance as a preventive measure lessens the likelihood of a failure.
Safety precautions
Read and follow the safety precautions in this guide to make sure you use the equipment safely.
See Safety precautions on page
You are expected to have the appropriate technical training and experience necessary to be aware
of hazards to which you may be exposed in performing a task, and to take appropriate measures to
minimize the risks to yourself and to others.
WARNING!
installation, the designated personnel receive training for safe operation and maintenance of the
product. No-one should use the product without this training.
The customer takes full responsibility for room layout, auxiliary equipment, personal protective
equipment (PPE), and working procedures, among other safety aspects, when processing powder and
performing the maintenance tasks specified in this chapter.
General cleaning instructions
For general cleaning, a lint-free cloth dampened with distilled water is recommended. Allow to dry, or use
a cloth to dry the cleaned part completely.
Do not spray fluids directly onto the HP product. Spray the fluid on the cloth used for cleaning.
To remove stubborn dirt or stains, moisten a soft cloth with water and a neutral detergent, or a general-
purpose industrial cleaner (e.g. Simple Green industrial cleaner). Remove any remaining soap foam with
a dry cloth.
For glass surfaces, is recommended to use a soft, lint-free cloth lightly moistened with a non-abrasive
glass cleaner or with general purpose glass cleaner (e.g. Simple Green glass cleaner). Remove any
remaining soap foam with a lint-free cloth dampened distilled water and dry it with a dry cloth to prevent
spotting.
CAUTION:
glass; they can damage it. Do not place or spray liquid directly onto the glass, as the liquid might seep
under the glass and damage the device.
CAUTION:
electrical circuits.
54 Chapter 4 Maintenance
Hardware maintenance may be performed by trained personnel only. During product
2.
Hardware maintenance may be performed by trained personnel only. During equipment
Do not use abrasives, acetone, benzene, sodium hydroxide, or carbon tetrachloride on the
Do not use water-based cleaners for parts with electrical contacts, as it may damage