Installing Or Removing An Internal Drive - Epson ExpressStation User Manual

3. Secure the drive with the four retaining screws.
4. Replace the drive housing and cover as described in
Chapter 2; then follow the "Post-installation Setup
Procedures" at the end of this chapter to update your
configuration.

Installing or Removing an Internal Drive

These instructions describe installing or removing either an IDE
or SCSI hard disk drive. Be sure to use the correct connector for
your drive.
Installing an infernal hard disk drive
Before you install an internal hard disk drive, be sure you do
the following (depending on the type of drive you will install):
your hard disk drive documentation for instructions.
On a SCSI drive, be sure to remove the drive's terminator
and set the SCSI ID appropriately for your system; see
Chapter 4 of this manual and your SCSI drive
documentation for instructions,
Then follow these steps to install the drive:
1. Position the drive housing so the disk drive riser board faces
upward and the back of the housing faces you.
Installing and Removing Options
3-19