Scsi Subsystem Problems - Epson ExpressStation User Manual

troubleshooting information and for any diagnostic
procedures you can perform.
program.

SCSI Subsystem Problems

Make sure that the cables connecting any external SCSI
devices are firmly inserted in their ports on the devices.
Verify that you have set the correct SCSI ID numbers and
properly installed the SCSI terminators. See Chapter 4 and
your SCSI device documentation for more information.
Be sure that you enabled the built-in SCSI controller,
disabled the built-in IDE hard disk controller, and set the
hard disk drive types to Not installed when you ran
the SETUP program or the System Configuration utility.
Also make sure that you disabled ROM BIOS shadow
control at addresses C0000 to CFFFF and 08000 to CBFFF to
avoid a memory conflict. See Chapter
Guide
If you are not using any external SCSI devices, be sure you
installed the external SCSI device terminator on the external
SCSI port. The terminator came in the box with your
computer. See Chapter 4 for more information.
If you have trouble with an internal SCSI hard disk drive
that you installed yourself, review the installation
instructions in Chapter 3 to make sure you performed all
the necessary steps.
If you still have trouble with the subsystem, contact your
dealer.
A-20 Troubleshooting
your
See Software Guide
for instructions.
for instructions.
or of the
1 2 Software