Removing Video Ram Chips; Installing And Removing Disk Drives - Epson ExpressStation User Manual

6. Gently but firmly press the chip into the socket. Check to
make sure it is completely seated and that none of the pins
are bent.
7. Set the video memory size jumper to indicate the amount of
video RAM you now have, as described on page 3-3.
8. Replace any option cards you removed. See page 3-6.

Removing Video RAM Chips

Do not attempt to remove the video RAM chips from your
main system board; ask your dealer to do it for you. This
procedure requires a special tool that your dealer must use to
remove the chip without damaging your equipment.

Installing and Removing Disk Drives

This section describes how to do the following:
Install or remove a diskette drive
You can install either a third- or half-height (SCSI or IDE)
3.5-inch hard disk drive in the internal drive bay. Your
third-height, 3.5-inch diskette drive is installed in the
externally-accessible front drive bay.
To install external SCSI devices, see Chapter 4 of this manual
and your SCSI device manuals for instructions.
Before you perform any of the procedures described in this
chapter, follow the steps in Chapter 2 to remove the computer's
cover and the drive housing.
3-16 Installing and Removing Options