Reinstalling A Diskette Drive - Epson ExpressStation User Manual

3. Replace the drive housing and cover as described in
Chapter 2; then follow the "Post-installation Setup
Procedures" at the end of this chapter to update your
configuration.

Reinstalling a diskette drive

Follow these steps to reinstall a diskette drive:
1. Turn the drive housing over so the disk drive riser board
faces upward.
2. Position the diskette drive so its mounting screw holes face
upward and the drive connector faces into the drive
housing. Then slide the drive into the housing.
Align the drive's connector pins with the holes in the drive
interface on the disk drive riser board and push the drive
into the interface. You may have to lift up the drive slightly
to align the pins.
3-18 Installing and Removing Options