Epson ExpressStation User Manual page 78

3. If you do not have a hard disk, insert a bootable diskette in
drive A. Turn on the computer and allow it to load the
operating system.
4. Then turn off the computer, remove the cover, and enable the
password function by moving main system board jumper
J21 from pins 2-4 to pins 4-6.
5. Replace the computer's cover.
If you do not want to set a new password, you do not need to
do anything else. (When you turn on your computer, you
will not see the Enter password prompt.)
If you want to set a new password, go to step 6.
6. If you ran the BIOS SETUP program to configure your
computer the last time, go to step 7. If you ran the System
Configuration utility, go to step 8.
7. If you do not have a hard disk, insert a bootable diskette in
drive A. Then turn on the computer.
When you see the prompt, press m to run SETUP. Follow
the instructions in your
power-on password using the BIOS SETUP program.
8. Insert the Reference diskette in drive A and turn on the
computer. Follow the instructions in Chapter 1 to set a new
power-on password using the EISA System Utilities.
9. If you need to activate your new power-on password as a
network password, see Chapter 1 for information about
using the EISA System Utilities to activate a network
password.
to set a new
Software Guide
Troubleshooting A-11