Table of Contents
Advertisement
13.4
Setting the display brightness
The ECO range of thermostats have a sensor which automatically adapts the display brightness according to the ambi-
ent light level. However, the automatic adaptation can be deactivated and the brightness set manually.
By pressing
-
13.5
Defining the starting mode (Autostart)
Generally, it is required that the thermostat starts operating again after a power interruption. For reasons of safety, for
example, you can insert a manual activation step.
By pressing
-
88 / 134
The adjacent menu window appears.
(ESC),
or
you are returned to the menu level without any change.
The adjacent menu window appears. As well as
setting is stated. This is "off" or "on"
If "off" is selected, standby operation is activated after a mains inter-
ruption.
With the setting "on" the device continues running straight after the
mains interruption.
or
(ESC) you are returned to the menu level without any change.
Access to the main menu level is obtained by pressing the enter
key
.
Selection and confirmation of
Display
Brightness.
Select "automatic", "level" or "off" with
is immediately active without confirmation.
Access to the main menu level is obtained by pressing the enter
key
.
Selection and confirmation of
Select
Autostart
with
.
Select the operating status "off" or "on" with
with
.
ECO Gold
Setup
Basic setup
or
. The selected level
Setup
Basic
setup.
Autostart
the current
or
and confirm
09/2021
Advertisement
Table of Contents
