Lauda Viscotemp 15 G Operation Manual page 26

Assembly as immersion thermostat
26 / 134
Place the bath vessel on a flat surface.
-
The control head is already screwed to the bath bridge.
-
In the rear part of the bath there are two slots present on the
bath edge. Guide the prongs of the bath bridge into the slots
to the right and left from the rear of the bath. Place the bath
bridge fully onto the bath bridge. Mount the bath bridge on
the rear of the bath with the two enclosed cross-head
screws.
Ensure that the ventilation opening at the back of the control
-
head is free.
Keep a distance of at least 20 cm free on all sides of the de-
-
vice.
Important: Set the flow distribution to INT so that during operation as
a bath thermostat (without external consumer) the flow is discharged
from the opening for the internal bath circulation.
When mounting the pump connection set, the outflow nozzle of the
pump set must be closed (use sealing plug) or connected to the return
nozzle by a hose.
For bath temperatures above 70 °C attach the sticker in-
-
cluded in the supplied items to an easily visible point on the
bath.
The control head must be removed when optionally fitting
-
the pump connection set ( 6.2). To do this, release the
two cross-head screws and carefully take the control head
out of the bath bridge.
ECO Gold 09/2021