Table of Contents
Advertisement
Step 27
1) Locate the winch and handle,
FIG 27- 1
2) Place handle on the winch and tighten with a 1/2" lock nut
3) take the cable clamp that was with the winch and mount it on the inside of the winch, you may need to
spread the cable clamp to make it fit the holes
4) Locate the hopper lift cable, Go to the transport arm for the swing hopper and feed the cable through the
end pulley
5) You will see the pulley at the bottom of the swing hopper transport arm; feed the cable around the pulley
6) Now pull the cable back to the winch, feeding it under the center of the winch and pulling it back on top
feeding it through the cable clamp
7) Once through the cable clamp push it through the side hold of the winch, attach the end of the cable to the
winch, and tighten the mounting bolts, now wind up the winch
Swing tube and hopper assembly
Step 28
1) Take the swing hopper to the main auger
2) Lift the auger and lower the auger to the main auger intake housing,(FIG 28-1) Line up the lower gear box
and the Knuckle assembly with deflector, spacer The knuckle with the deflector should slide onto the spline
shaft of the lower gear box
FIG 28- 2
3) lower the swing hopper onto the ground (FIG 28-2)
4) Locate 4 spacers, hold down part # 10170
5) locate the hold down swing hopper plates
Winch assembly
FIG 28- 1
Page 47 of 68
Advertisement
Table of Contents
