3) Then install the cable bracket and remaining
Step 4
1) after all bolts are in make sure to tighten them all down, work your way back down the tubes, so that you can
recheck and make sure you have not missed installing or tighten the tube junction bolts.
Discharge Assembly Installation
Step 5
1) You are ready to install the Discharge Assembly, (fig5-1) if you are transporting the auger you will need to install
the red flag provided to you.
2) Slide the discharge assemble down over the flighting at the top of the auger.
FIG 5- 1
Hub studs
FIG 5- 2
Flighting end hub
Discharge housing
Hub center
Page 14 of 68