Flighting And Tube Assembly - HARVEST H13112 Assembly Manual

Step 1
1) Lay out the tubes on blocks or stands at a height that is comfortable to you to work with, make sure to keep
the blocks or stands near the tube flanges this way you will not damage the tubes by denting them in,
Align holes and make sure that the flighting aligns is like in Figure 1.1 not 180 degrees off,
2) install and tighten (3)
Figure 1.2 the use of along tapered punch will help to align holes.
Align Bolt Holes

Flighting and Tube Assembly

Stud end of Flighting
FIG 1- 1
FIG 1- 2
Align Flighting
Receiver end of Flighting
Flighting properly aligned
as showing in
Page 12 of 68