You're Ready To Install The In-Feed Housing; Step 10; Step 11 - HARVEST H13112 Assembly Manual

You're ready to install the In-Feed Housing

Step 10

1) Start by sliding the in feed housing over the flighting that is protruding for auger tube one,
2) The in feed will have the tongue on one side and an opening the same size as the auger on the other,
3) Slide it back till it is against the auger tube flange, take (6)
heads are on the tube side and the thread are on the in feed side, the (4)
that the threads are on the tube side and the heads or on in feed side, use (10)

Step 11

1)
FIG 11- 1
2) Slide it over the top shaft which is located and protruding outwards towards the top of the in feed assemble, use
(4)
in feed housing, making sure that the grease fitting is pointing up,
3) Push on the locking collar against the bearing, turn the collar clockwise to lock, using a punch tap the lock collar
till tight. Tighten set screw on lock collar using Allen wrench.
Auger Tongue
Grease fitting
block
Auger flighting
shaft
FIG 10- 1
flange nuts tighten all bolts.
First tube assemble
Infeeder housing
Page 17 of 68