Step 7 - HARVEST H13112 Assembly Manual

Step 6
1) Watch the hub and line up the hub studs and the holes in the discharge assembly outer housing and finish
sliding the discharge assembly down so that it bottoms out onto the hub, (fig5-2) and install the (6)
assemble with lock washers between the nuts and discharge assembly.

Step 7

1) Using (10)
2) The bottom four bolts need to be inserted so that the bolt heads are on the inside, (fig 7.1) threads on the
outside of the discharge assembly so as to not be an area to slow down grain flow.
This are the bolts to make
sure threads are outside
the discharge chute
FIG 7- 1
FIG 6- 1
uts, bolt the discharge assembly to the auger tube flange.
This are the bolts to
make sure threads
are outside the
discharge chute
Page 15 of 68