Table of Contents
Advertisement
5.6
Performing One Button Tuning
Figure 5-4
Performing One Button Tuning
Proceed as follows to perform One Button Tuning:
1. Select "Commissioning > Optimization" in the navigation bar.
2. Select a dynamic setting according to the mechanical capabilities of your machine.
3. Activate additional increase of dynamics if the machine fulfills the displayed conditions.
4. Click "Take over control".
5. Click "Start optimization".
6. Enter the angle of rotation through which the motor and the connected machine are permitted to turn for the required
measurements (e.g. 360°) without the mechanical system being damaged.
The table shows how the settings have been changed by the One Button Tuning. If One Button Tuning was not
successful, then optimization must be repeated with other settings.
7. Click "Return control" once the controller has been optimized.
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
A5E52388930A AA, 07/2023
29
Advertisement
Table of Contents
