Lenovo 7Y45 Instructions Manual page 98

User Action:
Information only; no action is required
• FQXSPPP4054I: Unbalanced PSU config is detected, system is using less node PSU capacity.
This message is for the use case where user installed unbanlance PSU.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0316
User Action:
Information only; no action is required
• FQXSPPU0000I: [ProcessorElementName] in slot [SlotElementName] has been added.
This message is for the use case when an implementation has detected a Processor has been Added.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: PLAT CIM ID: 0034
User Action:
Information only; no action is required.
• FQXSPPU0001N: An Over-Temperature Condition has been detected on [ProcessorElementName].
This message is for the use case when an implementation has detected an Over-Temperature Condition
Detected for Processor.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Temperature
SNMP Trap ID: 0
CIM Prefix: PLAT CIM ID: 0036
User Action:
Complete the following steps until the problem is solved:
1. Check xClarity Controller (XCC) event log for any fan- or cooling-related issues.
2. Make sure that the airflow at the front and rear of the chassis is not obstructed and that fillers/airduct
are in place and correctly installed.
3. Make sure that the room temperature is within operating specifications.
4. Make sure that the microprocessor 1 heat sink is securely installed.
5. Make sure that the microprocessor 1 heat sink is installed correctly and the thermal material is
correctly applied.
6. Contact service for further support
• FQXSPPU0002G: The Processor [ProcessorElementName] is operating in a Degraded State.
94
ThinkSystem ST250 Messages and Codes Reference