Lenovo 7Y45 Instructions Manual page 171

User Action:
Information only; no action is required.
• FQXSFPU4085I: Host WOL boot order has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPW0001L: CMOS has been cleared.
Severity: Warning
User Action:
Complete the following steps:
1. If the CMOS clear was user initiated this event can be safely ignored and no further action is required.
2. If the system was recently installed, moved, or serviced, make sure the battery is properly seated.
3. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
error.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFSM0002N: Boot Permission denied by Management Module: System Halted.
Severity: Warning
User Action:
Complete the following steps:
1. AC cycle the system.
2. Check XCC logs,and make sure the PSU installation follows support guide line.
3. Review power policies and system configuration settings in the XCC GUI.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFSM0003N: Timed Out waiting on boot permission from Management Module: System
Halted.
Severity: Warning
User Action:
Complete the following steps:
1. AC cycle the system.
2. Check XCC logs,and make sure the PSU installation follows support guide line.
3. Review power policies and system configuration settings in the XCC GUI.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFSM0004M: An XCC communication failure has occurred.
Severity: Warning
User Action:
Complete the following steps:
1. AC cycle the system.
. 167
Chapter 3 UEFI events