Table of Contents
Advertisement
Complete the following steps:
1. Reseat the affected DIMM.
2. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
memory error.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFMA0076M: DIMM [arg1] is not supported, DIMM identifier is [arg2].
Severity: Warning
Parameters:
[arg1]: DIMM slot silklabel [arg2]: DIMM identifier consists of S/N, FRU and UDI, e.g. "739E68ED-VC10
FRU 0123456"
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Check user manual for supported DIMM types and replace the DIMM specified by the message with
a supported one.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0016N: A processor within the system has failed the BIST.
Severity: Error
User Action:
Complete the following steps:
1. If the processor or firmware was just updated, check the Lenovo Support site for an applicable
service bulletin or firmware update that applies to this processor error.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0017G: A processor microcode update failed.
Severity: Error
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
processor error.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0018N: CATERR(IERR) has asserted on processor [arg1].
Severity: Error
Parameters:
[arg1]: Socket number, 1-based.
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or UEFI firmware update that applies to
this processor error.
.
159
Chapter 3
UEFI events
Advertisement
Table of Contents
