Table of Contents
Advertisement
User Action:
Complete the following steps until the problem is solved:
1. Check if one of power supplies is missing, failed or not installed properly. If so, re-install it.
2. Check the power supply max rate and power capping policy. If the required power resource is not
met, change the power supply or modify power capping mechanism.
Note: If new components were installed into the system, this can raise the total system power
consumption and surpass the installed power supplies max rating. You may need to upgrade the
power supplies to accommodate the new system configuration.
3. Upgrade all system and chassis (if applicable) firmware to the latest level.
Note: If the device is part of a cluster solution, verify that the latest level of code is supported for the
cluster solution before the update.
4. Collect Service Data log.
5. Contact Lenovo Support.
• FQXSPPW2001I: [PowerSupplyElementName] has been removed from container
[PhysicalPackageElementName].
This message is for the use case when an implementation has detected a Power Supply has been
removed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: PLAT CIM ID: 0085
User Action:
Information only; no action is required.
• FQXSPPW2002I: [PowerSupplyElementName] has returned to OK status.
This message is for the use case when an implementation has detected a Power Supply return to normal
operational status.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Power
SNMP Trap ID: 4
CIM Prefix: PLAT CIM ID: 0087
User Action:
Information only; no action is required.
• FQXSPPW2003I: Failure no longer predicted on [PowerSupplyElementName].
This message is for the use case when an implementation has detected a Power Supply failure is no
longer predicted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Power
.
Chapter 2
XClarity Controller events
103
Advertisement
Table of Contents
