Lenovo 7Y45 Instructions Manual page 32

2. Make sure that the XCC Ethernet-over-USB interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for the operating system.
4. Disable the watchdog.
5. Check the integrity of the installed operating system.
• FQXSPBR4004I: Server timeouts set by user [arg1]: EnableOSWatchdog=[arg2],
OSWatchdogTimout=[arg3], EnableLoaderWatchdog=[arg4], LoaderTimeout=[arg5].
A user configures Server Timeouts
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0095
User Action:
Information only; no action is required
• FQXSPBR4005I: Management Controller [arg1]: Configuration saved to a file by user [arg2].
A user saves a Management Controller configuration to a file.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0109
User Action:
Information only; no action is required
• FQXSPBR4006I: Management Controller [arg1]: Configuration restoration from a file by user [arg2]
completed from [arg3] at IP address [arg4].
This message is for the use case where a user restores a Management Controller configuration from a file
and it completes.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0136
User Action:
Information only; no action is required
• FQXSPBR4007I: Management Controller [arg1]: Configuration restoration from a file by user [arg2]
failed to complete from [arg3] at IP address [arg4].
This message is for the use case where a user restores a Management Controller configuration from a file
and the restoration fails to complete.
Severity: Error
Serviceable: No
28
ThinkSystem ST250 Messages and Codes Reference