Lenovo 7D7M Reference page 148

Messages and codes reference
Table of Contents

Advertisement

3. Check the system spec to make sure that the PCIe device or NVME disk is installed in the compatible
PCIe slot or bay and a compatible cable is used. If not, performance of this device might be
impacted.
4. If the problem persists, collect Service Data logs.
5. Contact Lenovo Support.
• FQXSFIO0024I: An error has been detected by the IEH on processor [arg1]. The type of IEH is
[arg2]. The index of the IEH is [arg3]. The value of IehErrorStatus register is [arg4]. Please check
error logs for additional downstream device error data.
Severity: Warning
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or firmware update for the system or
adapter that applies to this error.
2. If the problem persists, collect Service Data logs.
3. Contact Lenovo Support.
• FQXSFIO0024M: An error has been detected by the IEH on processor [arg1]. The type of IEH is
[arg2]. The index of the IEH is [arg3]. The value of IehErrorStatus register is [arg4]. Please check
error logs for additional downstream device error data.
Severity: Error
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or firmware update for the system or
adapter that applies to this error.
2. If the problem persists, collect Service Data logs.
3. Contact Lenovo Support.
• FQXSFIO0025I: An error has been detected by the IIO on processor [arg1]. The index of the IIO
stack is [arg2]. The type of IIO Internal Error is [arg3]. Please check error logs for additional
downstream device error data.
Severity: Warning
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or firmware update for the system or
adapter that applies to this error.
2. If the problem persists, collect Service Data logs.
3. Contact Lenovo Support.
• FQXSFIO0025M: An error has been detected by the IIO on processor [arg1]. The index of the IIO
stack is [arg2]. The type of IIO Internal Error is [arg3]. Please check error logs for additional
downstream device error data.
Severity: Error
User Action:
Complete the following steps:
144
ThinkSystem SD650 V3 / ThinkSystem SD650-I V3 Neptune DWC Trays and DW612S Neptune DWC Enclosure Messages and
Codes Reference

Advertisement

Table of Contents
loading

Table of Contents