To Output Arbitrary Signals; To Select The Built-In Waveform - Aktakom AWG-4151 User Manual

To Output Arbitrary Signals

Press button to call the user interface of Arbitrary signal, the Arbitrary waveform
parameters can be set by operating the Arbitrary setting menu on the right.
The parameters of Arbitrary waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Built-in Waveform. You can operate the menu by using the menu
selection buttons on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to
"To Output Sine Signals" on P10.
The frequency range is 1μHz～10MHz; the period range is 100ns～1Ms.
The Arbitrary signal consists of two types: the system built-in waveform and the
user-definable waveform.
Current parameter
Parameter bar 1
Load
Amplitude
Offset
Parameter bar 2
Figure 5-11: The User Interface of Arbitrary Signal

To Select the Built-in Waveform

Press button, then press F4 to enter the Built-in Wform menu.
There are three built-in Arbitrary waveforms: Exponential Rise, Exponential Fall, sin(x)/x.
The Exponential Rise waveform is shown in the figure above (Figure 5-11). The
Exponential Fall and sin(x)/x waveform are shown in the figure below.
Frequency
Built-in Exponential
Rise Waveform
17
Current signal
Setting menu of
Arbitrary signal