Table of Contents
Advertisement
button to enter the file system, the storage menu will show "USBDEVICE" and
"FLASH".
(2) Enter the storage: Press the ◄ / ► direction key to choose the desired storage. Press
F1 to enter the chosen storage.
(3) Remove the U disk: Remove the U disk from the USB Host port on the rear panel.
The system will inform you "The USB device is removed", and the "USBDEVICE"
in the storage menu will disappear.
To Edit the File Name
In file system, the user can edit the name of a file or a folder. When the system needs the
user to input a name, an input keyboard will appear.
(1) Turn the knob or press the ◄ / ► direction key to move the cursor left and right in
the keyboard; press the ▲ / ▼ direction key to move the cursor up and down. Press
F3 to switch between capital and small of the characters.
(2) Press F1 to enter the current character. Press F2 to delete the last character .
(3) Press F4 to finish editing and save the file. Press F5 to cancel the save
operation.
Note: The length of file name is up to 15 characters.
To Set the Utility Function
Press Utility function key to enter the Utility Menu. You can set the parameters of the
Generator such as: Display Parameter, Output Parameter, Interface Parameter and System
Setting. Press Utility again to exit the Utility Menu.
To Set Display Parameter
To Set the Bright
(1) Press Utility and choose Disp Setup, press F1 to select Bright.
Figure 5-22: Edit the File Name
29
Advertisement
Table of Contents
