Table of Contents
Advertisement
Figure 5-2: Set the frequency using number keys
To Set the Amplitude
Press F2 , confirm whether the "Ampl" menu item is highlighted; if not, press F2 to
switch into "Ampl". In the Parameter bar 2, a cursor appears under the value of amplitude.
Use the knob or the number keys to set the desired value.
To Set the Offset
Press F3 , confirm whether the "Offset" menu item is highlighted; if not, press F3 to
switch into "Offset". In the Parameter bar 2, a cursor appears under the value of offset.
Use the knob or the number keys to set the desired value.
To Set the High Level
Press F2 , confirm whether the "Hi_Level" menu item is highlighted; if not, press F2
to switch into "Hi_Level". In the Parameter bar 2, a cursor appears under the value of
amplitude. Use the knob or the number keys to set the desired value.
To Set the Low Level
Press F3 , confirm whether the "Lo_Level" menu item is highlighted; if not, press F3
to switch into "Lo_Level". In the Parameter bar 2, a cursor appears under the value of
offset. Use the knob or the number keys to set the desired value.
To Output Square Signals
Press
button to call the user interface of Square signal, the Square waveform
parameters can be set by operating the Square setting menu on the right.
The parameters of Square waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Duty. You can operate the menu by using the menu selection buttons
on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to
"To Output Sine Signals" on P10.
The frequency range is 1μHz～50MHz; the period range is 20ns～1Ms.
11
Advertisement
Table of Contents
