To Set The Dc Output; To Set The I/O; To Set The Baud Rate; To Set The Lan - Aktakom AWG-4151 User Manual

 For the Burst, when the burst starts, the Sync Signal is Level High. At the specific
point when the Cycle Number ends, the Sync Signal turns Level Low (If the
Waveform has a relative starting phase, it may be not zero intersections). For an
infinite burst, the Sync Signal is the same with the Sync Signal of the continuous
Signal.
 For the External Gated Burst, the Sync Signal follows the External Gated Signal. But,
please note that this signal will not turn Level Low until the end of the last period (If
the Waveform has a relative starting phase, it may be not zero intersections).

To Set the DC Output

(1) Press Utility and choose Output Setup, press F3 to select DC.
(2) Press F3 to switch between On/Off.
(3) If On is selected, you can set the DC voltage. Turn the knob to change the value; or
press the number keys to input the desired value, press F1 or F2 to select the
unit.
DC Voltage

To Set the I/O

To Set the Baud Rate

Press Utility and choose I/O Setup, press F1 to choose BaudRate, press F1 to
switch the RS232 baud rate.
Make sure that the Baud Rate matches that of the computer. The optional rates are:
115.2K, 56K, 38.4K, 9.6K and 4.8K. The default setting is 115.2K.

To Set the LAN

Press Utility and choose I/O Setup, press F2 to choose LAN, enter the submenu.
Press F1 to set IP Addr, the range of each byte is 1～255.
Press F2 to set Port, the range is 1～4000.
Press F3 to set GateWay, the range of each byte is 1～255.
Current Parameter
Figure 5-23: The DC Setting Interface
32