To Output Pulse Signals - Aktakom AWG-4151 User Manual

Parameter bar 1
Input box
Symmetry

To Output Pulse Signals

Press button to call the user interface of Pulse signal, the Pulse waveform
parameters can be set by operating the Pulse setting menu on the right.
The parameters of Pulse waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Pulse Width/Duty, Edge Time. You can operate the menu by using the
menu selection buttons on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to
"To Output Sine Signals" on P10.
The frequency range is 1μHz～25MHz; the period range is 40ns～1Ms.
Current parameter
Parameter bar 1
Load
Amplitude
Offset
Pulse width
Parameter bar 2
Figure 5-7: The User Interface of Pulse Signal
Current parameter
Figure 5-6: Set the symmetry of Ramp signal
Edge time
Symmetry
Frequency
14
Current signal
Setting menu
of Pulse signal