User Interface; General Inspection - Aktakom AWG-4151 User Manual

⑪ USB Device port
⑫ Digital output

User Interface

①
②
③
④
⑤
⑥
⑦
Figure 4-3 User interface (take Sine for instance)
① Parameter bar 1, display parameters and edit the focused parameter
② Load, High Z represents high resistance
③ Frequency/period, depends on the highlighted menu item on the right
④ Amplitude/high level, depends on the highlighted menu item on the right
⑤ Offset/low level, depends on the highlighted menu item on the right
⑥ Display current waveform
⑦ Parameter bar 2, display parameters and edit the focused parameter
⑧ Current signal type or mode
⑨ The setting menu of current signal or mode
⑩ Signal type

General Inspection

After you get a new AWG Waveform Generator, it is recommended that you should make
a check on the instrument according to the following steps:
1. Check whether there is any damage caused by transportation.
If it is found that the packaging carton or the foamed plastic protection cushion has
suffered serious damage, do not throw it away first till the complete device and its
accessories succeed in the electrical and mechanical property tests.
such as connect a USB disk to the instrument.
Connect as a "slave device" with an external USB device,
such as connect the instrument to a PC.
7
⑧
⑨
⑩