To Set Signals; To Output Sine Signals; To Set The Frequency/Period - Aktakom AWG-4151 User Manual

To set signals

The following describes how to set and output Sine, Square, Ramp, Pulse, Noise and
Arbitrary signals.

To Output Sine Signals

Press button to call the user interface of Sine signal, the Sine waveform
parameters can be set by operating the Sine setting menu on the right.
The parameters of Sine waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level. You can operate the menu by using the menu selection buttons on the
right.
Parameter bar 1
Load
Amplitude
Offset
Parameter bar 2

To Set the Frequency/Period

Press F1 button, the chosen menu item is highlighted, the focused parameter is
displayed in Parameter bar 1. Press F1 button to switch between Frequency/Period.
Two methods to change the chosen parameter:
 Turn the knob to change the value of cursor position in the Parameter bar. Press the
◄ / ► direction key to move the cursor.
 Press a number key in the front panel, an input box will pop up; keep going to input
the value. Press the ◄ direction key to delete the last number. Press F1 ～ F3 to
choose the unit, or press F4 to go to next page and choose other units. Press F5
to cancel the input.
The frequency range is 1μHz～150MHz; the period range is 6.7ns～1Ms.
Current parameter
Sine waveform
Figure 5-1: The User Interface of Sine Signal
Frequency
10
Current signal
Setting menu
of Sine signal