Table of Contents
Advertisement
on P32. After restarting the Waveform Generator, if you can get data normally in the
ultrawave software, the connection is successful.
How to connect with the computer through a router:
(1) Connection. Use a LAN cable to connect the Waveform Generator with a router, the
LAN port of the Waveform Generator is in the rear panel; the computer should be
connected to the router too.
(2) Set the network parameters of the computer. Since the Waveform Generator can
not support obtaining an IP address automatically, you should assign a static IP
address. The Default gateway should be set according to the router. Here we set the IP
address to 192.168.1.71, Subnet mask is 255.255.255.0, Default gateway is
192.168.1.1.
Figure 6-4: Set the network parameters of the computer
(3) Set the network parameters of the ultrawave software. Run the software on the
computer; choose the "Ports-settings" of the "MENU". Set "Connect using" to LAN.
About the IP, the first three bytes is same as the IP in the step (2), the last byte should
be different. Here, we set it to 192.168.1.99. The range of the port value is 0～4000,
but the port which under 2000 is always be used, so it is suggested to set it to the
value above 2000. Here, we set it to 3000.
37
Advertisement
Table of Contents
