Aktakom AWG-4151 User Manual page 39

(2) Set the network parameters of the computer. Since the Waveform Generator can
not support obtaining an IP address automatically, you should assign a static IP
address. Here we set the IP address to 192.168.1.71, Subnet mask is 255.255.255.0.
Figure 6-2: Set the network parameters of the computer
(3) Set the network parameters of the ultrawave software. Run the software on the
computer, choose the "Ports-settings" of the "MENU". Set "Connect using" to LAN.
About the IP, the first three bytes is same as the IP in the step (2), the last byte should
be different. Here, we set it to 192.168.1.99. The range of the port value is 0～4000,
but the port which under 2000 is always be used, so it is suggested to set it to the
value above 2000. Here, we set it to 3000.
Figure 6-3: Set the network parameters of the ultrawave software
(4) Set the network parameters of the Waveform Generator. In the Waveform
Generator, press Utility and choose I/O Setup, press F2 to choose LAN, enter the
submenu. Set the IP Addr and the Port to the same value as the "Ports-settings" in
the software in step (3). About the setting method, please refer to "To Set the LAN"
36