To Output Noise Signals - Aktakom AWG-4151 User Manual

(2) Turn the knob to change the value directly;
or press the number keys to input the desired value and choose the unit.
The Edge Time range is 10nsec～40% of the Pulse Width.
Parameter bar 1
Input box
Edge time
Figure 5-9: Set the Edge Time of Pulse signal
Note:
The rising time and falling time of Pulse signal should have the same value by default.

To Output Noise Signals

Press button to call the user interface of Noise signal, the Noise waveform
parameters can be set by operating the Noise setting menu on the right.
The parameters of Noise waveform are: Amplitude/High Level, Offset/Low Level. You
can operate the menu by using the menu selection buttons on the right.
To set the Amplitude/High Level, Offset/Low Level, please refer to "To Output Sine
Signals" on P10.
Load
Amplitude
Offset
Parameter bar 2
Figure 5-10: The User Interface of Noise Signal
Current parameter
Noise
waveform
16
Edge time
Current signal
Setting menu of
Noise signal