Set The Gated Burst; To Save And Recall; To Use Usb Storage - Aktakom AWG-4151 User Manual

(9) Press F2 to select the source. Internal means using the internal source. External
means using the Ext Trig/FSK/Burst connector in the rear panel to input the external
signal. Manual means using the external source, set the start and stop time by hand.

Set the Gated Burst

Load
Start Phase
Gated
Waveform
Source
Waveform
Figure 5-21: The User Interface of Gated Burst
(1) When the output signal is Sine, Square, Ramp, Pulse or Arbitrary waveform, press
Burst function button to enter the Burst mode.
(2) Press ,
Take Sine for instance, press
can change the parameters, please refer to "To set signals" on P10. Press
button again to return to the Burst mode interface.
(3) Press F4 to switch to Gated.
(4) Press F3 to select Start Phase, define the Start and the Stop Point in a waveform.
The phase varies from -360° to +360°. For an Arbitrary Waveform, 0° is the first
waveform point.
(5) Press F5 to switch between Positive/Negative. Set the Polarity for the Gated
Signal.

To Save and Recall

Press Save function button to enter the file system.

To Use USB Storage

The storage location is divided into the internal storage (FLASH) and the U disk storage
(USBDEVICE). When a U disk is connected, the storage menu will show "USBDEVICE"
and "FLASH". Otherwise, the storage menu will show "FLASH" only.
(1) Install the U disk: insert a USB disk into the "⑩USB Host port" on the rear panel in
Figure 4-2, and the screen will show "Detect USB device". Press Save function
Current Parameter
, , or
to display the waveform and parameters. You
28
Positive
button to choose the waveforms.