Table of Contents
Advertisement
Figure 6-5: Set the network parameters of the ultrawave software
(4) Set the network parameters of the Waveform Generator. In the Waveform
Generator, press Utility and choose I/O Setup, press F2 to choose LAN, enter the
submenu. Set the IP Addr and the Port to the same value as the "Ports-settings" in
the software in step (3). The GateWay should be set according to the router. About the
setting method, please refer to "To Set the LAN" on P32. After restarting the
Waveform Generator, if you can get data normally in the ultrawave software, the
connection is successful.
Using COM Port
(1) Connection. Use a data cable to connect the COM port in the rear panel of the
Waveform Generator, to the COM port of a PC.
(2) Port setting of the software: Run the ultrawave software; click the "MENU" button
in the top right corner. Choose "Ports-Settings", in the setting dialog, choose
"Connect using" as COM.
To learn about how to operate the software, you can choose "MENU → Help" in the
software to open the help file.
38
Advertisement
Table of Contents
