Table of Contents
Advertisement
To Output Pulse Signals
Press
button to call the user interface of Pulse signal, the Pulse waveform
parameters can be set by operating the Pulse setting menu on the right.
The parameters of Pulse waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Pulse Width/Duty. You can operate the menu by using the menu
selection buttons on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to To
Output Sine Signals on page 12.
Channel
Load
Amplitude
Offset
Pulse width
Figure 5-8: The User Interface of Pulse Signal
5.Front Panel Operation
Figure 5-7: Set the symmetry of Ramp signal
Parameter 1
Parameter 2
Frequency
Parameter 3
16
Current signal
Setting menu
of Pulse signal
Advertisement
Table of Contents
