To Set Signals; To Output Sine Signals; To Set The Frequency/Period - Aktakom AWG-4152 User Manual

To set signals

The following describes how to set and output Sine, Square, Ramp, Pulse, Noise, Arbitrary,
DC signals and copy channel.

To Output Sine Signals

Press button to call the user interface of Sine signal, the Sine waveform
parameters can be set by operating the Sine setting menu on the right.
The parameters of Sine waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level. You can operate the menu by using the menu selection buttons on the
right.
Channel
Load
Amplitude
Offset
Sine

To Set the Frequency/Period

Press F1 button, the chosen menu item is highlighted, the focused parameter is
displayed in Parameter 1. Press F1 button to switch between Frequency/Period.
Two methods to change the chosen parameter:
 Turn the knob to change the value of cursor position. Press
move the cursor.
 Press a number key in the front panel, an input box will pop up; keep going to input
the value. Press
choose the unit, or press F4 to go to next page and choose other units. Press
F5 to cancel the input.
5.Front Panel Operation
Parameter 1
Parameter 2
Figure 5-2: The User Interface of Sine Signal
direction key to delete the last number. Press F1 -
Frequency
Parameter 3
12
Current signal
Setting menu
of Sine signal
/ direction key to
F3 to