Table of Contents
Advertisement
6
CONTROLS
6.6
Map‑Select switch for the basic setting
6.7
Map‑Select switch for vehicle operation
6.8
Overview of indicator lamps
6.9
Opening the filler cap
Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no fuel
is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with the
eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with soap and
water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel. Store fuel prop-
erly in a suitable canister and keep away from children.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
The Map‑Select switch for the basic setting
Possible states
1
2
3 - 9, 0
M00238-10
The Map‑Select switch for the basic setting is used to preselect the engine characteris-
tic.
The Map‑Select switch for vehicle operation
bar.
Possible states
The engine characteristic can be changed on the handlebar using the
M00239-10
Map‑Select switch for vehicle operation. This change is activated while the engine is
idling or on restarting.
Possible states
M00240-10
Soft – The mapping with reduced peak performance for better rideability
is activated.
ADVANCED – The mapping for performance with a very direct response
is activated.
Standard – The mapping for performance with a balanced response is
activated.
Standard – In this position, STANDARD Mapping is always activated.
SOFT or ADVANCED – In this position, the mapping that is set on
the Map‑Select switch for the basic setting is activated.
FI warning lamp (MIL) lights up/flashes orange – The OBD (onboard
diagnosis) has identified an emissions- or safety-critical fault.
is fitted under the seat.
is fitted on the right side of the handle-
12
Advertisement
Table of Contents
