Table of Contents
Advertisement
1.
INITIAL CONSOLE PROGRAMMING
When you first turn on Console power after all installation procedures have been
completed, the Console will display "US" in the display window.
must "calibrate", or program, the Console before it can be operated.
one-time operation which does not have to be repeated. Turning OFF the power switch
does not affect the Console memory.
IMPORTANT: If an entry selection error is made during Steps 1-6, place the
AUTO/MAN/OFF switch to the OFF position. Depress
placing the AUTO/MAN/OFF switch to AUTO or MAN.
console.
The following steps must be followed:
1)
Display US (acres), SI [hectares], or TU {1000 sq. ft.}.
Depressing momentarily
a)
b)
Depressing momentarily
c)
Depressing momentarily
2)
Selecting US, SI, or TU.
a)
To select US, SI, or TU, step
b)
Momentarily depress
3)
Display SP1 (wheel drives, etc.) or SP2 (radar).
a)
Depressing momentarily
b)
Depressing momentarily
4)
Selecting SP1 or SP2.
a)
To select SP1 or SP2, step with
b)
Momentarily depress
5)
Display C-Sd (Standard Valve), or C-FC (Fast Close Valve).
All data is retained.
steps the display from US to SI.
steps the display from SI to TU.
steps the display from TU to US.
until the desired code is displayed.
.
The display will now display SP1.
steps the display from SP1 to SP2.
steps the display from SP2 to SP1.
until desired code is displayed.
.
The display will now display C-Sd.
14
This means you
This is a
and hold while
This will "reset" the
Advertisement
Table of Contents
