Table of Contents
Advertisement
1. INITIAL CONSOLE PROGRAMMING
When you first turn on Console power, after all installation procedures have been
completed, the Console will display "US" in the display window.
must "calibrate" or program the Console before it can be operated. This is a one-
time operation which does not have to be repeated. Turning OFF the POWER ON/OFF
switch does not affect the Console memory. All data is retained in non-volatile
memory.
IMPORTANT:
IMPORTANT:
IMPORTANT:
IMPORTANT: If an entry selection error is made during Steps 1-4, place the power
IMPORTANT:
switch to the OFF position.
switch to ON.
The following steps must be followed:
1) Display US (gallons) or SI (liters).
1)
1)
1)
1)
a) Depressing momentarily
b) Depressing momentarily
2) Selecting US or SI.
2)
2)
2)
2)
a) To select US or SI, step with
b) Momentarily depress
3) Display C-Sd (Standard Valve) or C-FC (Fast Close Valve).
3)
3)
3)
3)
a) Depressing momentarily
b) Depressing momentarily
4)
4)
4) Selecting C-Sd or C-FC.
4)
4)
a) To select C-Sd or C-FC step
b) Momentarily depress
5) Enter METER CAL in key labelled:
5)
5)
5)
5)
6) Enter target LIQUID CAL application rate (GPT) [lit/MT] in key labelled:
6)
6)
6)
6)
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: A decimal point is displayed automatically. Therefore, twenty gallons per
ton is entered as 20.0, not 2.0.
7)
7) Enter initial GRAN CAL calibration number of 200 in key labelled:
7)
7)
7)
Depress
This will "reset" the Console.
.
.
and hold while placing the power
The display will now show "US".
steps the display from US to SI.
steps the display from SI to US.
until the desired code is displayed.
The display will now show C-Sd.
steps the display from C-Sd to C-FC.
steps the display from C-FC to C-Sd.
until desired code is displayed.
The display will now show CAL.
15
This means you
Advertisement
Table of Contents
